The tests were performed in two sessions lasting 1 hour each. The volunteers used the devices: door handle, tap, door pull handle, switch and door key to quantify hand strength. The tests were performed in two sessions lasting 1 hour each. The volunteers used the devices: door handle, tap, door pull handle, switch and door key to quantify hand strength.

In the first session, the volunteers performed the movements 3 times in each device of daily living activities with the right limb, with a 1-minute rest interval between the 3 measurements. The entire procedure performed in the session was repeated again after 30 minutes to verify the reliability and reproducibility of the Intra-evaluator test. The Inter-rater test was repeated after 7 days by the second rater to analyze reliability between the rater.

First, the hand measurements of each volunteer were evaluated, followed by the measurement of handgrip strength using the Jamar® dynamometer. And later the tests were performed using the system that contains the 5 devices to quantify the hand strength.

The strength of the cylindrical grip movement was quantified through the door handle device, the spherical grip strength through the tap device, the hook grip strength through the vertical door pull handle, the pulp-pulp pinch strength through the linear switch device and the pulp-side pinch strength through the key device. The test was quantified 3 times with a 1 minute interval between each test and the force throughout the range of motion.

Unit of measure: newton (N).

The test measured the range of motion of the door handle device, the tap device, door pull handle device and the door key device, 3 times with 1 minute interval for each test, in which all range of motion was measured from its start until its end. Unit of measure: Angle (º).

The anthropometric measurement of the right hand was performed using an analog caliper, as it is an important parameter for functional evaluation, as it was of the following anatomical parts: total length of the hand (wrist crease to middle finger tip), longitudinal length of the palm from the hand (wrist crease to the proximal crease of the middle finger) and transverse length of the palm (lateral to medial line of the metacarpophalangeal muscles). Unit of measure: millimeter (mm)